Seven assemblies, about $935 for the classic frame, bearings, seat and sensors, about $1,990 with throttle, pedals, a Quest 3 and MSFS 2024. See Parts & build for the full list.
Two A frame ends tied by side rails and a center cross support, all 2" PVC with screws, no glue. The stick support tees on the rails must rotate freely.
Change from the plans: the plans bend caster swivels into bearings, and the plans' own errata says the right caster is hard to find. Four UCFL204 flange bearings on 3/4" grade 8 axles do the same job off the shelf.
3" PVC rectangle. Rolls on the end bearings and carries the pitch bearings 39" back from the front, behind center because the pilot sits aft.
Scissor frame: A (1-1/4") and B (1") cross at a pivot bolt, C forms the nose, D is the V the stick bolts to. Slide the pipe straps on A fore and aft to balance the pilot at level.
A 1" aluminum lever with U joint brackets at both bolts. The pivot post rides on a U frame that hinges in the base rails, so pushing the grip forward pulls the cockpit's belly back and the nose drops.
Change from the plans: no gutted joystick and bungee cord under the seat. AS5600 encoders on the roll and pitch axles feed a Pro Micro running the included firmware. Throttle, pedals, and a Quest 3 plug in as normal USB devices.
Optional. Two 24V worm gear motors with crank arms and rod end pushrods, BTS7960 drivers, an Arduino on SMC3 firmware, and FlyPT Mover reading the sim's telemetry. E-stop in reach of the seat.
Geometry follows a 1997 PVC gimbal design, approximate where the drawings are not to scale.
Pilot's view terrain: the Houston metro from US Census TIGER roads and water and USGS 3DEP elevation (public domain). Skyline heights approximate; neighborhoods and traffic are generated.