Parts and build plan
The frame follows a 1997 PVC gimbal design: PVC, screws, no glue, a drill as the only power tool. This build keeps that geometry and swaps the parts that aged badly: real bearings instead of bent casters, magnetic encoders instead of a gutted joystick on an elastic band, and a modern VR headset. An optional powered kit adds motors.
What changes from the 1997 plans
| 1997 plans | This build |
|---|
Bill of materials Total
Sourced . Every line links to the listing to order from. Quantities are rounded up to whole packs. A ~ means the store would not show its price, so that one is an estimate. Prices are before tax and shipping. Tick the box when you order a line; it is saved in this browser. Untick a group to drop it from the total. A gaming PC is not included.
| Part | Need | Order from | Order | Price | Ext |
|---|
Shopping list by store
The same parts, grouped so you can place one order per store. Home Depot pipe is store pickup only; the other Home Depot lines can ride along with it.
Cut list
These are cut lengths, not center to center. Cut each one a pencil line long and file it square. Check the connector stub length against your fittings first, because brands differ in socket depth.
Build instructions
Wiring
| Pro Micro | Connects to |
|---|---|
| A0 | AS5600 roll, OUT |
| A1 | AS5600 pitch, OUT |
| VCC / GND | Both AS5600 VCC and GND, DIR tied to GND |
| 2, 3, 4, 5 | Trigger, button 2, 3, 4 (other side of each switch to GND) |
| 6, 7, 8, 9 | Hat up, right, down, left |
| USB | PC, through the hub on the rig |
| Uno | Connects to |
|---|---|
| A0 / A1 | Roll / pitch feedback pot wipers (5V and GND across the pots) |
| D9, D10 + enables | Roll BTS7960 RPWM, LPWM, R_EN, L_EN (per SMC3 pinout) |
| D11, D3 + enables | Pitch BTS7960 RPWM, LPWM, R_EN, L_EN |
| 24V supply | Through the E-stop relay to both BTS7960 B+ / B- |
| USB | PC running FlyPT Mover or SimHub |
Firmware: Pro Micro joystick Download .ino
Safety
- The plans tested the frame to 300 lb static. Add the EMT stiffeners and the rough rider braces if the primary pilot is over 170 lb or you fly aerobatics.
- Fit the side to side stops before anyone climbs in by leaning on the gimbal; that is the highest load the linkage sees.
- Powered build: E-stop in reach, keep bystanders 2 ft clear, set motor travel limits in software below the padded stops, and test empty before riding.